Accessories:1090MHz 3 Pole Filter (Type 2)

From Beast Wiki
Revision as of 06:25, 22 November 2013 by imported>Dl4mea
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
1090MHz 3 Pole Filter Type 2
(both ports SMA female)
Passband measured on a R&S FSEA with tracking generator
Upper: wideband showing 10dB bandwidth/div
Lower: narrow band, high resolution, showing 3dB bandwidth}

This filter is a new development. There are three major changes in comparison to the filter described in External Filters

  • The filter's passband is smaller than the previous 3 pole filter
  • It has a massive DC short on the input and the output protecting the connected devices from static electricity and lightening (*1)
  • The size is about half of the 3 pole filter of the first generation
  • Technical data:
    • passband attenuation: 0.5 dB
    • -3 dB bandwidth: better than 9 MHz
  • Options
    • Standard connectors are two SMA female connectors
    • The filter can made with N-female, N-male or BNC-female connectors each separately for both ends.
    • Both connectors can be placed on the same side
    • We can attach a massive M6 or M8 bolt on the side wall for a grounding strip
  • Dimensions
    • Length approximately 112 mm
    • Width approximately 30 mm
    • Height approximately 70 mm plus length of connectors
    • Weight approximately 0,275 kg (SMA female connectors)


Note that due to the connector options there are small predrills visible on the optional connector locations.

(*1) Not guaranteed a 100% protection, as there are other destructive ways.