Radarcape:Installation Guide

From Beast Wiki
Revision as of 16:17, 6 October 2013 by imported>Beastadmin
Jump to navigation Jump to search

Connect Radarcape Hardware

Plug the following connectors into the Radarcape

  1. Mode-S antenna
  2. GPS antenna
  3. Ethernet/LAN cable
  4. Power cable

Connect the power supply with the electrical outlet.

Software Configuration

Get DNS Name and IP Address of the Radarcape

The Radarcape obtains it's IP address via DHCP. Usually, the Internet router provides DHCP services in small networks (e.g., home network) and a list of distributed IP addresses can be obtained via it's web interface.


Set Root Password

In the default configuration, the no password is set for the root user (administrator) on the Radarcape. We strongly advise you to set a password for security reasons. Please remind your password as there is currently no other password recovery method than creating a new SD card image for your Radarcape.

First you must login to your Radarcape via SSH.

  • Windows users can use the free SSH client Putty.
  • Linux/Unix users may use SSH from the command line.

Please replace rs11.home with the DNS name or IP address of your personal Radarcape.

An initial root password has not been set. Therefore, you can login with user root and no password.

After you have logged in on your Radarcape, you can set a new root password with the following command:

passwd

Radarcape Password Change