Radarcape:Watchdog

From Beast Wiki
Revision as of 04:01, 7 July 2016 by imported>Dl4mea
Jump to navigation Jump to search
For Experts The tasks described in this manual require advanced knowledge of Unix/Linux.

Hardware Watchdog Overview

Starting with the 2nd production Batch, the Radarcape is equipped with a MAX6371 hardware watchdog. The watchdogs shall reboot the Radarcape in the case that the software hangs. This is especially important if the Radarcape is operated at remote locations or without a human operator available for a manual reboot. The AM3335 internal watchdog is not sufficient for such cases as it can only become activated after Linux has booted, so early faults would not be covered then.

The watchdog listens on GIPO_60 of the BeagleBone board for a toggling signal. If GIPO_60 has not been toggled within 1 minute, the BeagleBone board is being reset via the SYS_RESET pin. GIPO_60 must be toggled by software at least once every minute otherwise the Radarcape reboots. Toggling of GIPO_60 is usually being done by the Radarcape softawre (rcd). The very first timeout after power-on is 2 minutes, which leaves plenty of time for even reflashing the whole eMMC card.

Manual Hardware Watchdog Toggling

In certain situations it becomes necessary to temporarily stop or even de-install the Radarcape daemon. It then is necessary to toggle GIPO_60 by other ways to hinder the hardware watchdog from rebooting the Radarcape. This can be achived using the following script:

#!/bin/bash

echo *** Configure Watchdog retrigger pin & toggle first time

# Setup GIPO multiplexer (old firmware releases only)
if [ -e "/sys/kernel/debug/omap_mux/gpmc_ben1" ]
then
  echo 07 > /sys/kernel/debug/omap_mux/gpmc_ben1
fi

# Export GIPO_60 to /sys filesystem
echo 60 > /sys/class/gpio/export

# Set GIPO_60 direction to output 
echo out > /sys/class/gpio/gpio60/direction

# Toggle the pin until the user presses CTRL+C
echo 'Hit CTRL+C to exit'
while 1;
do
  echo 1 > /sys/class/gpio/gpio60/value
  sleep 15
  echo 0 > /sys/class/gpio/gpio60/value
  sleep 15
done

The toggling loop can also be typed as one-liner:

while :; do echo 1 > /sys/class/gpio/gpio60/value; sleep 15; echo 0 > /sys/class/gpio/gpio60/value; echo 'Hit CTRL+C to exit'; sleep 15; done


FAQ

F: The file /sys/kernel/debug/omap_mux/gpmc_ben1 does not exist on my Radarcape?
A: This file exists only on old Radarcape firmware. If it does not exist, ignore it and continue with the next command.

F: The message write error: Device or resource busy appears when I execute echo 60 > /sys/class/gpio/export. What shall I do?
A: In this case GIPO_60 has already be exported to the /sys file system. You can unexport it by typing echo 60 > /sys/class/gpio/unexport?