Radarcape:Specification: Difference between revisions
Jump to navigation
Jump to search
imported>Dl4mea |
imported>Dl4mea |
||
| Line 42: | Line 42: | ||
* SMB male GPS antenna connector | * SMB male GPS antenna connector | ||
More Information: [http://www.trimble.com/timing/resolution-smt.aspx] | More Information: [http://www.trimble.com/timing/resolution-smt.aspx|Trimble Resolution SMT web page] | ||
Revision as of 09:03, 7 October 2013
Radarcape
- The Radarcape consists of:
- Beaglebone (white) board
- Radarcape Mode-S receiver
- GPS module Trimble Resolution SMT
- Common case
- Power Consumption
- 5V external supply
- Standard 2.1 mm DC connector (plus inside, minus outside)
- without GPS, operating: typical 620mA
- with GPS (including antenna): typical 720mA
- Case
- Length approximately 92 mm (110 mm with antenna connector)
- Width approximately 80 mm
- Height approximately 45 mm
- Weight approximately 0.233 kg
Beaglebone Board (Rev. A6A)
- AM335x 720MHz ARM Cortex-A8
- 256MB DDR2 RAM
- 3D graphics accelerator (SGX530)
- 2x PRU 32-bit RISC CPUs
- Connectivity
- USB client (mini B receptacle)
- USB host (type A receptacle)
- 100Base-TX Ethernet
- 2x 46 pin headers (used by Radarcape board)
- microSD card with Angstrom Linux distribution
More Information: www.BeagleBoard.org
Radarcape Board
- FPGA based Mode-S ADS-B receiver
- SMA Mode-S antenna connector
GPS Module
- Trimble Resolution SMT GPS module
- SMB male GPS antenna connector
More Information: Resolution SMT web page