Mode-S Beast:Lantronix Xport Edge Software Setup: Difference between revisions

From Beast Wiki
Jump to navigation Jump to search
Line 9: Line 9:
[[File:Device-installer-xport-edge.png|420px|Mode-S Beast - Lantronix Device Installer showing Xport Edge]]<p>
[[File:Device-installer-xport-edge.png|420px|Mode-S Beast - Lantronix Device Installer showing Xport Edge]]<p>


==Setting up for UDP mode==
==Xport Edge Setup==
 
This mode is used in order to directly transfer data from the Mode-S Beast over the network to Planeplotter.
For Xport use, it is quite essential to use the binary format, so DIP#3 must be ON.
 
===Planeplotter Setup===
 
[[File:Xport-udp-pp-setup.gif|Xport UDP Planeplotter Setup]]
 
===Xport Network Setup===
 
Before doing any other work, you need to set the CPU Performance Mode to '''High''', press '''OK''' and then '''Apply Settings'''


[[File:Xport-server-settings.gif|700px|Xport Server Settings]]
[[File:Xport-server-settings.gif|700px|Xport Server Settings]]
====Xport Network Settings====
'''Important Note:''' While configuring, you always have to press '''OK''' button at the bottom, plus '''Apply Settings''' in the left hand menu.
[[File:Xport-network-settings.gif|700px|Xport Network Settings]]
===Xport Connection Settings===
[[File:Xport-connection-settings.gif|700px|Xport Connection Settings]]
===Xport Serial Settings===
Mind that here I was using 230400 baud rate, however 921800 is recommended.
[[File:Xport-serial-settings.gif|700px|Xport Serial Settings]]


==Setting up for TCP mode / COM port over Ethernet==
==Setting up for TCP mode / COM port over Ethernet==

Revision as of 10:35, 2 January 2020

The Lantronix Xport Edge is not fully supported by Lantronix Device manager, instead it offers all configuration on its internal web pages.

Lantronix Device Installer

Lantronix Device Installer can only show the IP address of the Xport Edge:

Mode-S Beast - Lantronix Device Installer showing Xport Edge

Xport Edge Setup

Xport Server Settings

Setting up for TCP mode / COM port over Ethernet

Newer versions of Planeplotter provide a direct TCP interface to the Xport, so data is not just streamed over the network but instead transmitted without loss and only if a device is connected.

Xport TCP Settings Example

Xport TCP Settings (1)

Xport TCP Settings (2)

You can also interface the TCP to the Lantronix Com Port Redirector, which installs a COM port for the application side.

Additional Hints

  • Factory reset without serial:
    Telnet to port 9999. Then you get a simple console menue, much like the BIOS setup of your PC. Simply do a factory reset, save and exit, and after a moment you will have it back on factory defaults.
  • Firmware upgrade of the Lantronix Xport:
    There is a FAQ of Lantronix, but ensure that the hardware revision of the Lantronix matches to that.
Retrieved from "https://wiki.jetvision.de/index.php?title=Mode-S_Beast:Lantronix_Xport_Edge_Software_Setup&oldid=3554"