Radarcape:Specification: Difference between revisions
Jump to navigation
Jump to search
imported>Beastadmin |
imported>Beastadmin |
||
| Line 1: | Line 1: | ||
=Radarcape= | =Radarcape= | ||
The Radarcape consists of: | * The Radarcape consists of: | ||
* Beaglebone board | ** Beaglebone board | ||
* Radarcape Mode-S receiver | ** Radarcape Mode-S receiver | ||
* GPS module (optional) | ** GPS module (optional) | ||
* Power Consumption | |||
** 5V external supply | |||
** Standard 2.1 mm DC connector (plus inside, minus outside) | |||
** without GPS, operating: typical 620mA | |||
** with GPS (including antenna): typical 720mA | |||
* Case | |||
** Length approximately 92 mm (110 mm with antenna connector) | |||
** Width approximately 80 mm | |||
** Height approximately 45 mm | |||
* Weight approximately 0.233 kg | |||
Revision as of 11:12, 5 October 2013
Radarcape
- The Radarcape consists of:
- Beaglebone board
- Radarcape Mode-S receiver
- GPS module (optional)
- Power Consumption
- 5V external supply
- Standard 2.1 mm DC connector (plus inside, minus outside)
- without GPS, operating: typical 620mA
- with GPS (including antenna): typical 720mA
- Case
- Length approximately 92 mm (110 mm with antenna connector)
- Width approximately 80 mm
- Height approximately 45 mm
- Weight approximately 0.233 kg
Beaglebone Board (Rev. A6A)
- AM335x 720MHz ARM Cortex-A8
- 256MB DDR2 RAM
- 3D graphics accelerator (SGX530)
- 2x PRU 32-bit RISC CPUs
- Connectivity
- USB client (mini B receptacle)
- USB host (type A receptacle)
- 100Base-TX Ethernet
- 2x 46 pin headers (used by Radarcape board)
- microSD card with Angstrom Linux distribution
More Information: www.BeagleBoard.org
Radarcape Board
- FPGA based Mode-S ADS-B receiver
- SMA Mode-S antenna connector
GPS Module
- Trimble Resolution T GPS module (optional)
- SMB GPS antenna connector
More Information: www.trimble.com