Revision as of 09:03, 7 October 2013

Radarcape

The Radarcape consists of:
- Beaglebone (white) board
- Radarcape Mode-S receiver
- GPS module Trimble Resolution SMT
- Common case
Power Consumption
- 5V external supply
- Standard 2.1 mm DC connector (plus inside, minus outside)
- without GPS, operating: typical 620mA
- with GPS (including antenna): typical 720mA
Case
- Length approximately 92 mm (110 mm with antenna connector)
- Width approximately 80 mm
- Height approximately 45 mm
Weight approximately 0.233 kg

AM335x 720MHz ARM Cortex-A8
256MB DDR2 RAM
3D graphics accelerator (SGX530)
2x PRU 32-bit RISC CPUs
Connectivity
- USB client (mini B receptacle)
- USB host (type A receptacle)
- 100Base-TX Ethernet
- 2x 46 pin headers (used by Radarcape board)
microSD card with Angstrom Linux distribution

Revision as of 09:03, 7 October 2013 (view source) imported>Dl4mea (→‎Radarcape) ← Older edit		Revision as of 09:03, 7 October 2013 (view source) imported>Dl4mea m (→‎GPS Module) Newer edit →
Line 42:		Line 42:
	* SMB male GPS antenna connector		* SMB male GPS antenna connector

	More Information: [http://www.trimble.com/timing/resolution-smt.aspx]		More Information: [http://www.trimble.com/timing/resolution-smt.aspx\|Trimble Resolution SMT web page]