Mode-S Beast:Lantronix Xport Edge Software Setup: Difference between revisions

From Beast Wiki
Jump to navigation Jump to search
← Older edit
 
(One intermediate revision by the same user not shown)
Line 11: Line 11:
==Xport Edge Setup==
==Xport Edge Setup==


[[File:Xport-server-settings.gif|700px|Xport Server Settings]]
Line Settings must specifiy the "Tunnel" Protocol in order to provide a transparent tunnel


==Setting up for TCP mode / COM port over Ethernet==
[[File:Xport-Edge-010-Line-Settings.png|Xport Edge Line Menu Settings]]


Newer versions of Planeplotter provide a direct TCP interface to the Xport, so data is not just streamed over the network but instead transmitted without loss and only if a device is connected.
Tunnel is configured to the port 10001


===Xport TCP Settings Example===
[[File:Xport-Edge-020-Tunnel-Settings.png|Xport Edge Tunnel Accept Settings]]


[[File:Xport-tcp-settings1.png|640px|Xport TCP Settings (1)]]<p>
Tunnel Packing enabled so not every single byte causes a frame to be transmitted
[[File:Xport-tcp-settings2.png|640px|Xport TCP Settings (2)]]<p>


[[File:Xport-Edge-025-Tunnel-Packing-Settings.png|Xport Tunnel Packing Settings]]


Select hardware handshake


[[File:Xport-Edge-026-Tunnel-Line-Settings.png|Xport Edge Tunnel Hardware Handshake Settings]]


You can also interface the TCP to the [http://www.lantronix.com/device-networking/utilities-tools/com-port-redirector.html Lantronix Com Port Redirector], which installs a COM port for the application side.
Pin configurations for hardware handshake require configuration


===Additional Hints===
[[File:Xport-Edge-030-CPM-Settings.png|Xport Edge Line Menu Settings]]
 
* '''Factory reset without serial:'''<br>Telnet to port 9999. Then you get a simple console menue, much like the BIOS setup of your PC. Simply do a factory reset, save and exit, and after a moment you will have it back on factory defaults.
* '''Firmware upgrade of the Lantronix Xport:'''<br>There is a [http://ltxfaq.custhelp.com/app/answers/detail/a_id/1597 FAQ of Lantronix], but ensure that the hardware revision of the Lantronix matches to that.

Latest revision as of 11:00, 2 January 2020

The Lantronix Xport Edge is not fully supported by Lantronix Device manager, instead it offers all configuration on its internal web pages.

Lantronix Device Installer

Lantronix Device Installer can only show the IP address of the Xport Edge:

Mode-S Beast - Lantronix Device Installer showing Xport Edge

Xport Edge Setup

Line Settings must specifiy the "Tunnel" Protocol in order to provide a transparent tunnel

Xport Edge Line Menu Settings

Tunnel is configured to the port 10001

Xport Edge Tunnel Accept Settings

Tunnel Packing enabled so not every single byte causes a frame to be transmitted

Xport Tunnel Packing Settings

Select hardware handshake

Xport Edge Tunnel Hardware Handshake Settings

Pin configurations for hardware handshake require configuration

Xport Edge Line Menu Settings

Retrieved from "https://wiki.jetvision.de/index.php?title=Mode-S_Beast:Lantronix_Xport_Edge_Software_Setup&oldid=3561"