Revision as of 09:03, 7 October 2013

Radarcape

The Radarcape consists of:
- Beaglebone (white) board
- Radarcape Mode-S receiver
- GPS module Trimble Resolution SMT
- Common case
Power Consumption
- 5V external supply
- Standard 2.1 mm DC connector (plus inside, minus outside)
- without GPS, operating: typical 620mA
- with GPS (including antenna): typical 720mA
Case
- Length approximately 92 mm (110 mm with antenna connector)
- Width approximately 80 mm
- Height approximately 45 mm
Weight approximately 0.233 kg

AM335x 720MHz ARM Cortex-A8
256MB DDR2 RAM
3D graphics accelerator (SGX530)
2x PRU 32-bit RISC CPUs
Connectivity
- USB client (mini B receptacle)
- USB host (type A receptacle)
- 100Base-TX Ethernet
- 2x 46 pin headers (used by Radarcape board)
microSD card with Angstrom Linux distribution

More Information: [1]

@@ Line 2: / Line 2: @@
 * The Radarcape consists of:
-** Beaglebone board
+** Beaglebone (white) board
 ** Radarcape Mode-S receiver
-** GPS module (optional)
+** GPS module Trimble Resolution SMT
-** Shared case
+** Common case
 * Power Consumption
 ** 5V external supply
@@ Line 16: / Line 16: @@
 ** Height approximately 45 mm
 * Weight approximately 0.233 kg
 ==Beaglebone Board (Rev. A6A)==
@@ Line 37: / Line 36: @@
 * FPGA based Mode-S ADS-B receiver
 * SMA Mode-S antenna connector
 ==GPS Module==
-* Trimble Resolution T GPS module (optional)
+* Trimble Resolution SMT GPS module
-* SMB GPS antenna connector
+* SMB male GPS antenna connector
-More Information: [http://www.trimble.com/timing/resolution-t.aspx www.trimble.com]
+More Information: [http://www.trimble.com/timing/resolution-smt.aspx]